Alpha 6000 - Display Control (Group PC)

Chapter 5 Parameter Introductions
146
Pb.07 CCF6 Fault Handling
Range:0,1【0】
0: Not generate fault and keep running 1: Generate fault and stop
Note:
 This function code is used to decide whether to generate communication fault or
not. When the value is 1, if communication fault occurs, the keyboard will display
CCF6 and the inverter stop as fault occurs; when the value is 0, it doesn't generate
the fault and the inverter will keep on running.
5.13 Display Control (Group PC)
PC.00 LCD Language selection
Range: 0,1【0】
0: Chinese, display Chinese prompt in LCD screen;
1: English, display English prompt in LCD screen.
Note:
 PC.00 is effective for the panel with LCD screen, and the LED panel only
displays segment code of characters and digits.
 Only 35R5GB/37R5PB and above inverter models can be equipped with the LCD
keyboard.
PC.01 Output frequency (Hz) (Before compensation)
Range: 0,1【1】
PC.02 Output frequency (Hz) (Actual)
Range: 0,1【0】
0: No display
1: Display
Note:
 If PC.01 is set to 1, output frequency (before compensation) will be displayed with
unit “Hz” in monitoring state, and the unit indicator “Hz” will be lit up. If it is set to
0, the object will not be displayed.
 If PC.02 is set to 1, output frequency (actual) will be displayed with unit “Hz” in
monitoring state, and the unit indicator “Hz” will be lit up. If it is set to 0, it will not
be displayed.
PC.03 Output current (A)
Range: 0,1【1】
0: No display 1: Display
Note:
 If PC.03 is set to 1, output current will be displayed with unit “A” in monitoring
state, and the unit indicator “A” will lit up. If it is set to 0, output current will not be
displayed.
PC.04 Reference frequency (Hz, flashes)
Range: 0,1【1】
0: No display 1: Display
Note:
 PC.04 can be set to 1 and press shift key >> can switch to reference frequency
monitoring in monitoring state. When switch to reference frequency monitoring,