3. Release the wing nuts (Fig. 117/2).
4. Adjust the height of the level sensor (Fig.
117/1) to the required seed volume.
AMATRON 3 emits an alarm when the level
sensor is no longer covered with seed.
5. Tighten the wing nuts (Fig. 117/2).
117
Only machines with two metering units:
6. Repeat the setting on the second level sensor.
Fasten the two level sensors at the same height in the seed
hopper.
Increase the residual seed volume which triggers the alarm:
• the greater the sowing rate
• the greater the working width.
Cirrus BAH0049-1 09.14
117
To Next Page
Loading...
Need help?
General
