10.4 Move the exact harrow into the working position
Only Cirrus 3002 with exact harrow
To drive on the road, the exact harrow is pushed
inside itself so that the permitted transport width
of 3.0 m is not exceeded.
Before using the machine on the field
1. Undo the bolt and push the outside harrow
element (Fig. 173/1) outwards.
2. Tighten the bolt.
3.
Repeat the operation on the second outside
harrow element.
Fig. 173
The coulters on the seed drill force the soil outwards to different ex-
tents depending on the travel speed and condition of the soil. Push
the outside harrow element further outwards at higher travel speeds.
Set the outside harrow elements such that the soil is guided back
and a trackless seed bed is created.
Check the settings before starting work.
10.5 Filling the seed hopper
DANGER
Fill the seed hopper on the field only!
Transport journeys on roads and ways are prohibited when the
seed hopper is filled. The brake system is designed only for an
empty machine.
Before filling the seed hopper apply the tractor parking brake,
switch off the tractor engine and remove the ignition key!
Observe the approved filling levels and total weights!
1. Couple the Cirrus to the tractor.
2. Apply the tractor parking brake, switch off the engine and re-
move the ignition key.
3. Determine and fit the dosing roller(s).
156 Cirrus BAH0049-1 09.14
To Next Page
Loading...
Need help?
General
