General Safety Instructions
2.10 Constructive changes
You may make no changes, expansions or modifications to the ma-
chine without the authorisation of AMAZONEN-WERKE. This is also
valid when welding support parts.
Any expansion or modification work shall require the written approval
of AMAZONEN-WERKE. Only use the modification and accessory
parts released by AMAZONEN-WERKE so that the operating permit,
for example, remains valid in accordance with national and interna-
tional regulations.
Vehicles with an official type approval or with equipment connected to
a vehicle with a valid type approval or approval for road transport
according to the German road traffic regulations must be in the state
specified by the approval.
WARNING
Risk of contusions, cuts, dragging, catching or knocks from
support parts.
It is forbidden to:
• Drill holes in the frame or on the running gear.
• Increasing the size of existing holes on the frame or the running
gear.
• Welding support parts.
Cirrus BAH0049-1 09.14
17
To Next Page
Loading...
Need help?
General
