Cleaning, maintenance and repairs
12.3 Cleaning the machine
DANGER
Wear a face mask. Do not inhale toxic dressing dust when re-
moving dressing dust by means of compressed air.
• Pay particular attention to the brake, air and hydraulic hose
lines.
• Never treat brake, air and hydraulic hose lines with benzene,
benzole, petroleum or mineral oils.
• After cleaning, grease the machine, in particular after cleaning
with a high pressure cleaner / steam jet or liposoluble agents.
• Observe the statutory requirement for the handling and removal
of cleaning agents.
Cleaning with a pressure cleaner / steam cleaner
Always observe the following points when using a high pressure
cleaner / steam jet for cleaning:
• Do not clean any electrical components.
• Do not clean any chromed components.
• Never aim the cleaning jet from the nozzle of the high pressure
cleaner / steam jet directly on lubrication and bearing points.
• Always maintain a minimum jet distance of 300 mm between the
high pressure cleaning or steam jet cleaning nozzle and the ma-
chine.
• Comply with safety regulations when working with high pressure
cleaners.
1. To clean, always place the machine connected to the tractor on
the sustainer (Fig. 112/1).
2. Fold the machine out and lower it fully by moving in the integrat-
ed running gear completely.
3. Empty the seed hopper and seed dosing unit.
4 Clean the distributor head.
5. Clean the machine with water or with a high-pressure cleaner.
6. If you raise the machine, secure the raised machine before you
start the cleaning.
178 Cirrus BAH0049-1 09.14
To Next Page
Loading...
Need help?
General
