General Safety Instructions
Hydraulic braking system for export machines
• Hydraulic brake systems are not approved in Germany.
• When filling up or replacing the brake fluid, use the prescribed
hydraulic fluids. When replacing the hydraulic fluids, comply with
the appropriate regulations.
2.16.7 Tyres
• Repair work on tyres and wheels may only be carried out by
specialists with suitable installation tools.
• Check the air pressure at regular intervals.
• Comply with the prescribed air pressure! If the air pressure in the
tyres is too high, then there is a risk of explosions!
• Park the machine in a safe place and lock the machine against
unintentional falling and rolling (parking brake, wheel chocks),
before carrying out work on the tyres.
• Tighten or retighten all the fixing screws and nuts in accordance
with the specifications of AMAZONEN-WERKE!
2.16.8 Operation of the seed drill
• Comply with the permitted filling volumes of the seed hopper
(seed hopper content).
• When filling the seed hopper, only use the ladder and the load-
ing board.
It is forbidden to ride on the machine during operation!
• During the calibration test, note the danger points from rotating
and oscillating machine parts.
• Before transportation, remove the thrust collars of the tramline
marker.
• Do not place any parts in the seed hopper.
• Before transportation, lock the track marker (construction-
dependent) in the transport position.
Cirrus BAH0049-1 09.14
39
To Next Page
Loading...
Need help?
General
