General Safety Instructions
2.16.3 Electrical system
• When working on the electrical system, always disconnect the
battery (negative terminal).
• Only use the prescribed fuses. If fuses are used that are too
highly rated, the electrical system will be destroyed – danger of
fire!
• Ensure that the battery is connected correctly -
positive terminal and then connect the negative terminal. When
disconnecting the battery, disconnect the negative terminal first,
followed by the positive terminal.
• Always place the appropriate cover over the positive battery
terminal. If there is accidental earth contact, there is a danger of
explosion!
• Danger of explosion! Avoid the production of sparks and naked
flames in the vicinity of the battery!
• The machine can be equipped with electronic components, the
function of which may be influenced by electromagnetic interfer-
ence from other units. Such interference can pose risks to peo-
ple, if the following safety information is not followed.
ο In the case of retrofitting of electrical units and/or compo-
nents on the machine, with a connection to the on-board
power supply, the user must check whether the installation
might cause faults on the vehicle electronics or other com-
ponents.
ο Ensure that the retrofitted electrical and electronic compo-
nents comply with the EMC directive 89/336/EEC in the ap-
propriate version and carry the CE label.
36 Cirrus BAH0049-1 09.14
To Next Page
Loading...
Need help?
General
