Visual inspection of the distributor heads
From time to time, check the distributor heads for impurities.
Contamination and seed remains can block up the distributor heads
and have to be removed immediately.
Seeding with difficult soil conditions
Mud holes can be passed through and seeded by partially or fully
raising the disc array and the coulter frame. During this procedure, the
star wheel remains in operational position (se operating manual
AMATRON 3).
10.10 Turning at end of the field
Before turning at the end of the field
1. Slow down your travel speed.
2. Do not reduce the tractor's rotational speed
too far so that the hydraulic functions con-
tinue without interruption at the headland.
3. Actuate control unit yellow.
4. Turn the combination as soon as the ma-
chine or coulter frame is raised.
182
After turning at the end of the field
1. Operate the control unit yellow for at least 5 seconds so that all
hydraulic functions are fully executed after turning.
2. Start the field run as soon as the disc array touches the ground.
DANGER
After turning, if control unit yellow
is actuated the opposite track
marker is moved to the operational position.
Cirrus BAH0049-1 09.14
165
To Next Page
Loading...
Need help?
General
