Cleaning, maintenance and repairs
12.5.6 Service brake system:
dual-circuit pneumatic braking system - hydraulic braking system
The Cirrus is equipped with a dual-circuit pneumatic braking system
with a hydraulically actuated brake cylinder.
The dual-circuit pneumatic braking system does not actuate as nor-
mally a rod or brake cable connected to the brake shoe.
The dual-circuit pneumatic braking system acts on a hydraulic cylin-
der, which actuates the hydraulic brake cylinder of the brake shoes in
the brake drum.
WARNING
The service brake system does not have a parking brake!
Always use wheel chocks before uncoupling the machine from
the tractor.
If the visual inspection, function or action testing of the service brake
system shows any signs of deficiencies, have a thorough inspection
of all components performed immediately at a specialist workshop.
CAUTION
Observe the legal regulations for all service work.
Only genuine spare parts may be used.
The brake valve settings laid down by the manufacturer must not
be altered.
DANGER
Only specialist workshops or recognised brake services
may perform adjustment and repair work on the brake sys-
tem.
Have the brake system checked regularly.
Be particularly careful with welding, burning and drilling
work in the vicinity of brake lines!
No welding or soldering may be performed on valve fittings
or pipes. Any damaged parts must be replaced.
Always perform a braking test after any adjusting or repair
work on the braking system.
For servicing and maintenance work on the braking system
observe the section "
Safety information for users", Seite 31.
Cirrus BAH0049-1 09.14
191
To Next Page
Loading...
Need help?
General
