8.8 Adjusting the disc array (on the field)
8.8.1 Adjusting disc array working depth
with machine setting "Turning on the axle"
Adjust the disc array working depth immediately before starting work
on the field.
Correct the setting, if necessary without interruption during work.
DANGER
Direct people out of the danger area.
1. Select the button
(see operating manual AMATRON 3).
→ The symbol
appears on the display.
2. Actuate control unit green until the desired disc array working
depth is reached.
The working depth of the discs array determines the working intensity.
When the symbol disappears from the display, the disc array
actuation is deactivated.
The disc array actuation is deactivated as soon as another selection
is made, e.g. harrow pressure adjustment.
Cirrus BAH0049-1 09.14
131
To Next Page
Loading...
Need help?
General
