5.5 Operator control terminal AMATRON 3
The AMATRON 3 consists of the operator control
terminal (Fig. 57), the basic equipment (cable
and fastening material) and the job computer on
the machine.
The following are performed via the operator
control terminal
• input of the machine-specific data
• input of the job-related data
• control of the machine to change the sow-
ing rate during sowing operation
(electronic seed rate adjustment is neces-
sary)
• switching clear of the hydraulic functions
before the hydraulic functions can be exe-
cuted via the appropriate control unit
• monitoring of the seed drill during sowing
operation.
57
• the instantaneous travel speed [km/h]
• the instantaneous sowing rate [kg/ha]
• the distance [m] remaining until the seed hopper is emptied of
seed
• the actual seed hopper content [kg].
Once a job has been started, the AMATRON 3 stores
• the day and total seed volume output [kg]
• the day and total area cultivated [ha]
• the day and total sowing time [h]
• the average performance [ha/h].
Cirrus BAH0049-1 09.14
65
To Next Page
Loading...
Need help?
General
