Ametek MX Series - Page 24

User Manual – Rev BE AMETEK Programmable Power
MX Series 24
Programmable Output Impedance (available on MX30-3Pi and MX45-3Pi in three phase mode only.)
(For MX22.5 ,please consult with factory)
Range:
R: 1 – 200 mOhm
L: 170 – 200 uH
Resolution:
R: 1 mOhm
L: 1 uH
Accuracy: 10 % FS
Multiple Cabinet Systems
Output
Parameter
MX6 0
MX9 0
MX135
MX180
MX225
MX270
Mo des
Std Controller AC, DC
Pi Controller AC, DC, AC+DC
Voltage:
Ranges (L-N) :
AC Mo d e
Standard Models: Low: 0 - 150 V / High: 0 - 300 V
-333 option: Lo w: 0 - 166 V / High: 0 - 333 V
DC Mo d e
Standard Models: Low: 0 - 200 V / High: 0 - 400 V
-333 option: Lo w: 0 - 220 V / High: 0 - 440 V
AC+DC Mod e
Standard Models: AC: Lo w: 0 - 150 V / High: 0 - 300 V
-333 option: Lo w: 0 - 166 V / High: 0 - 333 V
DC Offset: Low Vrange: 0 - 150 V
High Vrange: 0 - 220 V (Series II) / High; 0 – 250 V (Series I).
NOTE: On MX units with standard controller, only one voltage range is available unless the -R range change option is installed.
Resolution:
Re s ol ut io n
AC Mo d e
0.1 V
Re s ol ut io n
DC Mo d e
0.1 V
Re s ol ut io n
AC+DC Mod e
AC: 0.1 V
DC Off s e t :
Series I 0.01 V < 2.5 V
0.1 V 2.5 - 25 V
1 V > 25 V
Series II 0.01 V
Accuracy:
± 0.3 V AC mode
± 1 V DC m o d e
Distortion THD
1
:
(Resistive full load)
MX units shipped before 2009
< 1 % @ 16 - 66 Hz
< 2 % @ 66 - 500 Hz
< 3 % @ > 500 Hz
MX units shipped as of 2009
< 0.5 % @ 16 - 6 6 Hz
< 1.00 % @ 66 - 500 Hz
< 1.50 % @ > 500 Hz
1 The distortion specification for the MX Series is valid for pure (inductance < 12 uH) resistive load conditions and using a 30 KHz Low
Pass filter on distortion meter.
Load Regulation:
0.25 % FS @ DC - 100 Hz
0.5 % FS @ > 100 Hz