3-7 VNA Key Functions - Preset Menu Chapter 3 — Vector Network Analyzer
3-48 MS20xxA VNA Master UG 10580-00166 Rev. C
Preset Menu
To access the Preset Menu, press the Shift key, then the Preset (1) key. The Preset menu is
used to preset the VNA Master. Additional selections are possible to save and recall setups.
Preset
This soft key resets sweep conditions to default state of full band sweep, 275 data
points, S21 Log Mag display, High output power, continuous sweep, and it turns off
markers, limits, and calibration.
Save Setup
This soft key opens a dialog box to name and save the current operating settings,
allowing them to be recalled later in order to return the instrument to the state it was
in at the time that the setup was saved. The saved setup can be named by using the
keypad to select numbers, by using the rotary knob to highlight a number or character
and pressing the knob to select, or by selecting the soft key for each letter. Use the
Shift
key to select an upper case letter. Use the Left/Right directional arrows to move the
cursor position. Press
Enter to save the setup.
Recall Setup
This soft key brings up a selection box that allows selection and recall of a previously
stored instrument setup. Use the rotary knob or the Up/Down arrow keys to highlight
the saved setup and then press
Enter, the rotary knob, or the Recall soft key to select. All
current instrument settings are replaced by the stored setup information. Press the
Esc
key to cancel the recall.
Figure 3-27. Preset Menu
Preset
Preset
Save
Setup
Recall
Setup
10580-00166C.book Page 48 Thursday, February 21, 2008 12:52 PM
To Next Page