B-4 Interference Analyzer Information Messages Appendix B — Error Messages
B-10 MS20xxA VNA Master UG 10580-00166 Rev. C
B-4 Interference Analyzer Information Messages
ADC Over range: Increase Reference Level
Attempting to lock to ext ref
Attempting to lock to External ref
Attempting to lock to Internal ref
Attenuation has been changed
Cannot change scale in Linear mode
Cannot turn on delta marker because Ref Marker is a counter Marker
Changing Active trace to A
Connect Carrier\Press Enter to Measure or Escape to Exit
Current Marker is not ON
Disconnect Carrier\Press Enter to Measure or Escape to Exit
IF Cal is OFF
Minimum permitted Sweep time is 10µs
Mixer Saturation: Increase Attenuation
Preamp has been turned off
Preamp has been turned on
Press ESC to clear Recall Trace
Press Escape to keep old settings, or Enter to use Recalled Values
Reference Level has been changed
Reference Locked Successfully
Reference LVL Cal is OFF
Startup DSP Memory test successful
10580-00166C.book Page 10 Thursday, February 21, 2008 12:52 PM
To Next Page
Loading...
