B-5 Interference Analyzer Error Messages Appendix B — Error Messages
B-12 MS20xxA VNA Master UG 10580-00166 Rev. C
B-5 Interference Analyzer Error Messages
Auto Save not available when Time Span is Auto
Cannot change average for Recalled/Inactive Traces
Cannot set Delta Mkr Freq to Demod Freq
Current measurement is stopped when Cursor is not zero
DDC Failure
DSP Memory Failure
Fatal error not decoded by DSP
Fatal error, EEPROM failed
Fatal error, no IA board connected
Fatal error, Unknown
Hidden inflection points prevent this action. Decrease Span to reveal hidden
points.
Invalid Attenuation for PreAmp Setting
Lock attempt Failed
Lock failed during initialization
Lock failure %x
Locking to External Ref failed
Locking to Internal Ref failed
Marker must be ON to Use the feature
Measurement has been turned OFF
Measurement not valid in Zero Span
Measurements can not be displayed in Full Screen mode
Only HOLD is valid for Trace B
10580-00166C.book Page 12 Thursday, February 21, 2008 12:52 PM
To Next Page