Appendix B — Error Messages B-5 Interference Analyzer Error Messages
MS20xxA VNA Master UG 10580-00166 Rev. C B-13
Only HOLD is valid for Trace C when trace C is not being updated from A
Operation not Permitted in Recall Mode
Operation not Permitted in this Mode
OVER POWER ERROR
Pretune Calibration Failure
The Freq range of the Antenna is invalid for this setup. Please select another
Antenna
The specified Time span is too big to save all measurements. Automatically
adjusted Time Span to a valid number
Timed Measurement Done. Press Reset/Restart Meas to continue measuring
Trace A has no data to view
Trace B has no data to view
Trace C has no data to view
Trace not saved. Please wait for complete sweep and try again.
Triggering valid only in Zero Span
Turning off Trace Overlay
Unable to add additional limit points. %d is the maximum.
UNKNOWN ERROR In IA
10580-00166C.book Page 13 Thursday, February 21, 2008 12:52 PM
To Next Page
Loading...
