EasyManua.ls Logo

Anritsu MS2024A/MS2026A - System Requirements

Anritsu MS2024A/MS2026A
310 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
13-3 System Requirements Chapter 13 — Master Software Tools
13-2 MS20xxA VNA Master UG 10580-00166 Rev. C
• Handle long file names for easy, descriptive data labeling
• Store an unlimited number of data traces to a PC easing the task of analyzing and
monitoring historical performance
• Create and download new signal standards, Pass/Fail Mode custom lists and
antenna factors to existing lists into the unit
• Establish a connection to a PC using USB, Ethernet LAN, or Direct Ethernet
• Coordinate cell site locations using Map Point and GPS location mapping
13-3 System Requirements
Minimum requirements and recommendations are:
• Microsoft Windows 2000 or Windows XP
• Intel Pentium 233 MHz microprocessor minimum (Pentium II 350 MHz or better
recommended)
• 128 MB of RAM minimum (256 MB or above recommended)
• Hard disk drive with approximately 80 MB of available space (An additional
80 MB free space for storage of captured plots is recommended.)
• A USB port (USB 1.2 required, USB 2.0 recommended) or an Ethernet 10/100 T
connection for communication with the instrument
13-4 Installation
To install the Master Software Tools program, insert the Anritsu Master Software Tools disk
in the CDROM drive. Follow the instructions in the installation program to install the
software. If the autorun feature is disabled in your computer, then click on the Windows
Start
menu, and select
Run. Type: X:\Setup.exe, where X is the drive letter of the CDROM drive, and
follow the instructions in the installation program.
The
readme.doc file on the disk provides updated information about the program, and the Help
function provides detailed operating information from within the program.
To start the Master Software Tools program, double-click on the
Master Software Tools desktop
icon, or select
Programs from the Windows Start menu and select Anritsu, then Master Software
Tools
to launch the program.
Note
Master Software Tools requires Windows 2000 or Windows XP. Master Software
Tools will not function on earlier versions of the Microsoft Windows operating
system, as the program relies on the Windows 2000 and Windows XP .NET
Framework
10580-00166C.book Page 2 Thursday, February 21, 2008 12:52 PM

Table of Contents