MS20xxA VNA Master UG 10580-00166 Rev. C 10-1
Chapter 10 — Channel
Scanner, Option 27
10-1 Introduction
This chapter presents Channel Scanner information and procedures. The Channel Scanner
option (Option 27) measures the signal power of multiple transmitted signals. The power can
be displayed as either a bar graph or a text display showing the channel power of selected
channels for a given air interface standard, or the manually entered channels. Up to
20 channels can be measured.
The operating frequency range for Channel Scanner mode can either be set manually, or the
desired air interface standard can be selected from the Signal Standard and channel list in
the instrument. When the channels are selected from the Signal Standard list, all frequency
related parameters for the standard are automatically set to the appropriate values. The
frequency and bandwidth settings can be manually entered using the Scan Frequencies
selection if none of the available air interface standards meet the measurement need. A
custom channel list can also be created to allow up to 20 independent channels to be defined.
10580-00166C.book Page 1 Thursday, February 21, 2008 12:52 PM
To Next Page
Loading...
