Chapter 10 — Channel Scanner, Option 27 10-3 Custom Setup
MS20xxA VNA Master UG 10580-00166 Rev. C 10-3
10-3 Custom Setup
Procedure
1. On the VNA Master, select the Shift key, then the Mode (9) key.
2. Use the directional arrow keys or the rotary knob to highlight
Channel Scanner and press
the
Enter key to select.
3. Press the
Custom Setup key.
4. Press the
Number of Channels soft key to define how many channels to include in the
custom list. This choice can be changed later if needed.
5. Press the
Edit List soft key to bring up the list of channels. The channel highlighted in
blue is the channel active for editing. Use the up and down arrows to select the channel
to edit. Each channel can be set up differently.
6. Press either the
Select Signal Standard soft key or the Set Freq soft key. If the Select Signal
Standard soft key was selected, then select the desired air interface standard from the
dialog box displayed. When a standard is selected, the usual bandwidth for that
standard is automatically set. The bandwidth can be changed if desired. After the air
interface standard is selected, press the
Set Channel soft key to enter the desired channel
number.
7. If the Set Freq soft key was selected, then the frequency value of the active channel will
be highlighted in a red box. Use the rotary knob or the numeric key pad to enter the
desired center frequency in Hz, kHz, MHz, or GHz.
8. Press the
Set Bandwidth soft key and use the rotary knob or numeric keypad to enter the
desired value in Hz, kHz, MHz, or GHz.
9. Repeat 5. through 8. for all channels.
10580-00166C.book Page 3 Thursday, February 21, 2008 12:52 PM
To Next Page