Chapter 8 — Vector Voltmeter, Option 15 8-7 Vector Voltmeter Mode Menus - CW Menu
MS20xxA VNA Master UG 10580-00166 Rev. C 8-9
8-7 Vector Voltmeter Mode Menus
In the Vector Voltmeter mode, the function hard keys display the following labels: “CW”,
“Table”, “Save/Recall”,
and “Cal”. The fifth function hard key has no function in the Vector Volt
Meter mode.
CW Menu
In Continuous Wave, the meter displays the selected frequency and indicates if calibration is
ON or OFF for that specific frequency. The instrument must be calibrated for each chosen
frequency.
The return measurement format units are displayed near the center of the vector volt meter
window. For
dB format, the units are dB and deg (degrees). For VSWR format, the units are
VSWR. For
Imped (impedance) format, the units are Ohms and jOhms.
The measurement type and format are displayed at the bottom of the Vector Voltmeter
window.
CW Frequency #.### GHz, MHz, kHz, Hz
Press this soft key to set the desired measurement frequency. Enter the desired
frequency using the keypad, the arrow keys, or the rotary knob. If entering a frequency
using the keypad, then the soft key labels change to
GHz, MHz, kHz, and Hz. Select the
appropriate units key. Selecting the
Enter key has the same affect as using the MHz soft
key.
Figure 8-8. CW Menu
Clear
Reference
Save
New
Reference
Return Meas Format
dB VSWR Imped
Measurement Type
Return Insertion
CW Frequency
2.710 GHz
CW
10580-00166C.book Page 9 Thursday, February 21, 2008 12:52 PM
To Next Page
Loading...
