4-24 Freq (Frequency) Chapter 4 — Spectrum Analyzer
4-36 MS20xxA VNA Master UG 10580-00166 Rev. C
Signal Standard
Use the
Up/Down arrow keys or the rotary knob to highlight a signal standard and press
Enter to select.
When a signal standard is selected, the center frequency and span for the first channel
of the particular standard is automatically tuned. Other settings, such as channel
spacing and integration bandwidth, are also automatically entered.
Appendix A, "Signal Standards" contains a table of the signal standards that are in the
instrument firmware.
Channel #
Use the
Up/Down arrow keys, the keypad, or the rotary knob to select a channel number
for the selected signal standard. The center of the channel is tuned to the center of the
spectrum analyzer display.
10580-00166C.book Page 36 Thursday, February 21, 2008 12:52 PM
To Next Page
Loading...
