3-7 VNA Key Functions - File Menu Chapter 3 — Vector Network Analyzer
3-32 MS20xxA VNA Master UG 10580-00166 Rev. C
Delete ALL Mode Files
Deletes all measurements of the type saved in the current operating mode of the
instrument. In addition all jpg and setup files (regardless of the mode) are
deleted.
Delete ALL Contents
Deletes all measurements, jpg files and setup files of ALL measurement types.
Back
The Back key returns to the previous menu.
Directory Management
Brings up the Directory Management soft menu. Note that the Directory Management
menu is available from the File, Recall, and Save menus.
Sort Method Name Type Date
File lists can be sorted by the name of the file, the type of file (SPA file, STP file,
etc.) or by the date that the file was saved.
Sort Ascend Descend
Selects whether the selected sort is sorted from lowest to highest (ascending) or
highest to lowest (descending). When sorting by name, the sort will place file
names that start with numbers before file names that start with letters (an
ASCII sort).
Current Location Int USB CF
This choice lets you select where measurements and setups will be saved.
Pressing the soft key selects the storage location to be the internal memory, USB
Flash drive, or Compact Flash memory module. The “current location” and the
“copy to destination” will never be the same. Changing the current location to
save files causes the “copy to destination” to be automatically changed if the
selected storage location is the same as the selected current location.
Copy to Destination Int USB CF
This choice lets you select where measurements and setups in the “current
location” will be copied. The “current location” and the “copy to destination” may
not be the same. If you change the destination to which the instrument will copy
files, the current location is automatically changed if the current location is the
same as the selected copy to destination.
Copy From Current Location To Destination
Pressing this soft key causes all measurements, setups, and jpg files that are
stored in the user-selected “current location” to be copied to the “copy to
destination”. If no storage module is installed in the instrument, an error
message is displayed.
Format Compact Flash
This selection erases all files on an installed Compact Flash module. A message
is displayed warning that all files will be erased. Press Enter to confirm that you
want to erase, or Esc to quit without erasing. In addition to erasing all files
stored on the Compact Flash, the /usr directory is created for storage of
measurements, setups and jpg files.
Back
The Back key returns to the previous menu.
10580-00166C.book Page 32 Thursday, February 21, 2008 12:52 PM
To Next Page
Loading...
