CPS100 SERIES OPERATION MANUAL
SECTION 6:
Front Panel Operation
Entire Contents Copyright 2018 by Adaptive Power Systems, Inc. (APS) • All Rights Reserved • No reproduction without written authorization from APS.
APS CPS100 Series Power Source Operation Manual Page 143 of 231
6.9.4.2 Triac Dimmer Test
The Triac test simulates the voltage
waveform associated with SCR controlled
light dimmers. This test mode is useful for
testing lighting products.
To select the Triac Dimmer test mode, press
the Triac Dimmer soft key in the Special Func
menu.
The Triac Dimmer test can be set up from the
Edit screen. Press the Edit soft key to enter
Edit mode.
Available Triac parameters are:
• Edge Leading or Lagging
• Degree: 0 ~ 359.9 degrees
When done, press the Save soft key to save
the transient settings to non-volatile
memory.
Note: If the setting is not saved, it will be
lost when the power source is turned
off.
To Next Page
Loading...