Aspen Avionics Evolution EFD1000 PFD - LIMITED WARRANTY Aspen Avionics, Inc

EFD1000 PFD Pilot’s Guide
Page viii A-01-184-00 REV B
EFD1000 PFD Pilot’s Guide
EFD1000 PFD Pilot’s Guide
LIMITED WARRANTY
Aspen Avionics, Inc.
1. YOUR WARRANTY. Aspen Avionics, Inc. (“Aspen”) warrants to you,
the original purchaser, that its Products (if purchased from an authorized
dealer) will comply with applicable specications (as set forth in the
owner’s manual) in all material respects and will be free from material
defects in workmanship or materials for a period of twenty-four (24)
months beginning with the date that the aircraft in which the Product has
been installed has been returned to service following installation by an
Aspen authorized dealer (“Return to Service Date”). “Product” means new
end equipment or hardware items, replaceable units and components of
those units.
2. YOUR REMEDY. During the term of this warranty, Aspen will repair
or replace, at its discretion, without charge (see Section 13 below for
information on covered transportation costs), any Product that does
not comply with the warranty of Section 1 above (a “Nonconforming
Product”), so long as the warranty claim is timely submitted and the
procedures in Section 14 (below) are followed. Aspen warrants repaired
and/or replacement items only for the unexpired portion of the original
warranty period, or, if the warranty has expired, for six months from
Aspen’s shipment of the repaired or replacement Product.
3. CONDITIONS TO COVERAGE. Aspen’s obligation under this
warranty is conditioned on your fulllment of the obligation to:
A. Maintain records accurately reecting operating time of and
maintenance performed on the Product,
B. Furnish proof sucient to establish that the item is a
Nonconforming Product, and
C. Allow Aspen access to all relevant records in order to
substantiate your warranty claim.
4. EXCLUSIONS. The following are not covered by (and are expressly
excluded from) this warranty:
A. Normal wear and tear and the need for regular overhaul and
maintenance,
B. Exposure of the Product to temperature, environmental,
operating, or other conditions other than those prescribed in
the owner’s manual,
C. Failure to install or operate the Product as prescribed in the
owner’s manual or as Aspen otherwise directs,
D. Alterations or repairs made by anyone other than Aspen or its
authorized service center,