Aspen Avionics Evolution EFD1000 PFD - 4.3.7. CDI Selected Course

CHAPTER 4, REFERENCE GUIDE
EFD1000 PFD Pilot’s Guide
Page 4-30 A-01-184-00 REV B
EFD1000 PFD Pilot’s Guide
EFD1000 PFD Pilot’s Guide
4.3.7. CDI Selected Course
When the CDI source changes from a GPS source with AUTOCRS to another CDI source,
the CRS value reverts to the last set value. When the CDI source is set to a VHF receiver
operating in the VOR or Localizer modes, editing the CRS value adjusts the current
selected CRS value. When the CDI source is set to a GPS receiver, and AUTOCRS is
disabled, the CRS value may be adjusted.
Select CDI Course
1. Press the Left Knob until CRS displays above the Left Knob and the Course
eld is enabled for editing, both rendered in magenta (Figure 4-68).
2. Rotate the Left Knob to change the value of the Course eld. Rotate clockwise
to increase, or counterclockwise to decrease, the value. Once the CRS value
is set, and after 10 seconds of inaction, the CRS eld is disabled and both the
label and eld are rendered in cyan.
Figure 4-68
CRS Field Enabled for Editing