EFD1000 PFD Pilot’s Guide
CHAPTER 2, CONTROLS AND DISPLAY
EFD1000 PFD Pilot’s Guide
EFD1000 PFD Pilot’s Guide Page 2-5A-01-184-00 REV B
When the function you want to set is shown in magenta, dial the knob left or right to
set the desired value, or press and hold the knob to synchronize (SYNC) the setting.
Once set, you can either press the knob again to advance to the next function you’d like
to set, or you can do nothing and in 10 seconds the knob will return to its home state
(CRS or HDG).
2.2.1.1. Right Knob Functions
The Right Knob Home state is Heading (HDG). The Right Knob is also used to set the
Altitude Alerter seleted altitude (ALT), barometric pressure (BARO) and instrument
approach minimums (MIN). Successive presses of the right knob will cycle through
HDG-ALT-BARO-MIN in round-robin sequence.
From the inactive Home state (HDG shown in cyan above the right knob):
Press once to set the heading bug (HDG) (• Refs. 50 and 51).
Press twice to set target altitude (ALT) (• Refs. 22 and 25).
Press three times to set barometric pressure (BARO) (• Ref. 37).
Press four times to set approach minimums (MIN) (• Ref. 27).
2.2.1.2. Left Knob Functions
The Left Knob Home State is Course (CRS). The Left Knob is also used to set the
Airspeed Bug (IAS).
From the inactive Home state (CRS shown in cyan above the left knob):
Press once to set the course (CRS) (• Refs. 44 and 49, and see note at right
about Auto Course).
Press twice to set the airspeed bug (IAS) (• Refs. 31 and 32).
NOTE
MIN will only be shown if the MIN
function is already active (the MIN
label by the second Hot Key (Ref. 5)
is shown in green, and the MIN value
is shown on the Attitude Display
(Ref. 27). If the MIN function is
inactive (label in gray), pressing the
MIN Hot Key will both activate the
function and immediately make it
available for setting.
NOTE
When the CDI navigation source is
selected to a GPS receiver, and Auto
Course is enabled in the main menu
(see Section 4.3.6), the course is set
automatically by the GPS and is not
pilot-adjustable. This case will be
indicated by the CRS eld and Knob
label being shown in Green with an
inverse “A”. In this case, pressing the
Left Knob will enable you to set only
the airspeed bug (IAS).
To Next Page
Loading...
