EasyManua.ls Logo

AudioCodes MP-20x - Performing an ARP Test; Figure 14-20: Advanced - Diagnostics - Statistics

AudioCodes MP-20x
270 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Version 3.0.1 225 July 2010
MP-20x Telephone Adapter 14. Advanced Settings
3. Click the Go button; after a few seconds, diagnostic statistics are displayed. If no new
information is displayed, click the Refresh button.
Figure 14-20: Advanced - Diagnostics - Statistics
14.5.2 Performing an ARP Test
The Address Resolution Protocol (ARP) test is used to query the physical address (MAC)
of a host.
¾ To run the ARP test:
1. In the 'Destination' field, enter an IP address of the target host.
2. Click Go; after a few moments, diagnostic statistics is displayed. If no new information
is displayed, click Refresh.

Table of Contents

Related product manuals