Version 3.0.1 87 July 2010
MP-20x Telephone Adapter 9. LAN Wireless Connection
9 LAN Wireless Connection
You can configure MP-20x's wireless connection, using one of the following methods:
'Quick Setup' screen (Quick Setup menu - refer to 'Configuring VoIP Parameters' on
page 37) - m
ainly for enabling wireless.
'Network Connections' screen (Network Connections menu), for (enabling wireless)
advanced wireless settings, as discussed in this section.
Note: To establish a wireless network connection between a computer and the MP-
20x, you must also configure the PC for wireless (refer to 'Wireless LAN
Connection' on page 22).
¾ To access the Network Connections Screen for configuring wireless
connection:
1. From the sidebar menu, click the Network Connections menu; the 'Network
Connections' screen appears.
Figure 9-1: Network Connections Screen Listing LAN Wireless Interface
The 'name' column denotes the wireless LAN connection as 'LAN Wireless 802.11g
Access Point'. The 'Status' column indicates whether the wireless connection is
enabled or disabled ("Connected" or "Disconnected").
2. Click the Edit icon in the 'Action' column corresponding to the 'LAN Wireless 802.11g
Access Point' network name; the 'LAN Wireless 802.11g Access Point Properties'
screen appears, displaying the contents of the General tab.
For a description of the tabs of the 'LAN Wireless 802.11g Access Point Properties' screen,
refer to the following:
General tab - refer to 'General Tab' on page 88
Setting
s tab - refer to 'Settings Tab' on page 88
Wireless tab
- refer to 'Wireless Tab' on page 89
Adv
anced tab - refer to 'Advanced Tab' on page 103
To Next Page
Loading...
Need help?
General
