PARTNER Phone Administration Page 102
- Issue 1b (22 February 2010)IP Office PARTNER Version
12.4 Line Ringing
For incoming calls alerting at an extension, each line appearance button can be set to ringing immediately, delayed ring
or no ring.
For the system administration extensions (10 and 11), you can view and change the line ringing setting of extensions.
From each extension, you can also view the current line ringing settings of the phone but you cannot change them.
To view and change an extension's line ringing settings (ETR 18D/34D)
1.At one of the system administration telephones (extension 10 and 11), press Feature 00 followed by two presses
of Intercom 1 and one press of Intercom 2. Centralized Programming: is shown on the display.
2.At the Extension: prompt enter the number of the extension.
3.Enter the number of the extension to be programmed.
4.At the Button: prompt enter from 03 to 80 to select the line button for which you want to view the line ringing
setting.
5.The display will show LINE RINGING: and the current ring setting for the line on that button and the line number
it represents in the form <ring setting>-L<line number>.
· I- = Immediate ring.
· D- = Delayed ring (5 seconds delay).
· N- = No ring.
6.To change the setting from its current value enter the button number again.
7.To view the setting of another line button enter the number of that button.
· Exit programming by pressing Feature 00. You can also exit programming mode by lifting the handset, then place
it back in the cradle.
To view and change an extension's line ringing settings (1408/1416 Phone)
1.At extension 10 or 11, press Admin.
2.Use the up or down arrow buttons to scroll the display to Centralized Programming. When displayed,
press Select.
3.At the Extension: prompt enter the extension that you want to configure.
4.Use the up or down arrow buttons to scroll the display to Line Ringing. When displayed, press Select.
5.At the Button: prompt enter from 03 to 80 to select the line button for which you want to view the line ringing
setting. Or press the corresponding line appearance button directly.
6.The display will show LINE RINGING: and the current ring setting for the line on that button and the line number
it represents in the form <ring setting>-L<line number>.
· I- = Immediate ring.
· D- = Delayed ring (5 seconds delay).
· N- = No ring.
7.To change the setting from its current value enter the button number again.
8.To view the setting of another line button enter the number of that button.
· Exit programming by pressing PHONE/EXIT. Alternatively use the Back button to move to another menu.
To Next Page
Loading...
