PARTNER Phone Administration Page 70
- Issue 1b (22 February 2010)IP Office PARTNER Version
8.3 Call Waiting
Use this feature to activate call waiting. When you are on a call and a second intercom, transferred or outside call comes
in, you hear a beep to indicate you have a second call waiting to be answered. Press the switch hook (or Recall or Flash
button, if available) to put the current call on hold and retrieve the second call. To return to the first call, press the switch
hook again.
· This feature is distinct from the local telephone company’s Call Waiting feature. If you use this system feature, do
not use your local telephone company’s Call Waiting feature.
· The Call Waiting tone is not repeated.
· Call waiting is only supported for single-line telephone extensions. Do not assign Call Waiting to extensions that
have fax machines, credit card scanners, modems or auto attendants because the call-waiting tone interrupts the
data connection.
· You cannot transfer either party connected by call waiting, conference in additional parties or use feature codes
while both calls are active.
· Transfer-return, group call distribution and hunt group calls are not considered incoming calls for this feature.
To change an extension's call waiting setting (ETR 18D/34D)
1.At a system administration extension (10 and 11); with the phone idle press Feature 0 0 followed by two presses
of Intercom 1. System Administration: is shown on the display.
2.Dial #316. The phone displays Call Waiting.
3.At the Extension: prompt enter the number of the extension to be programmed.
4.Enter the appropriate value:
· 1 = Assigned.
· 2 = Not Assigned (the default setting).
· Exit programming by pressing Feature 00. You can also exit programming mode by lifting the handset, then place
it back in the cradle.
To change an extension's call waiting setting (1408/1416 Phone)
1.At either of the system administration telephones (extensions 10 and 11), with the phone idle press Admin.
2.Use the up or down arrow buttons to scroll the display to System Administration. When displayed, press
Select.
3.Use the up or down arrow buttons to scroll the display to Extensions. When displayed, press Select.
· Alternatively, dial # and the same code as used by ETR phones for system administration .
4.Use the up or down arrow buttons to scroll the display to Call Waiting. When displayed, press Select.
5.At the Extension: prompt enter the extension you want to edit.
6.The current setting is displayed.
7.Enter 1 or 2. Alternatively use the left or right arrow icons to toggle the settings or Default to return to the
default setting.
· 1 = Assigned.
· 2 = Not Assigned (the default setting).
8.Use the up or down arrow buttons to select another extension to adjust if required.
· Exit programming by pressing PHONE/EXIT. Alternatively use the Back button to move to another menu.
7
To Next Page
Loading...
