PARTNER Phone Administration Page 158
- Issue 1b (22 February 2010)IP Office PARTNER Version
15.8 System Reset
Use this feature to reset the system while retaining the currently programmed settings. Reset the system only when
advised to do so by technical support personnel.
· WARNING
This process will restart the phone system and disconnect all currently connected calls.
· The system reset begins immediately. It takes approximately 5 minutes.
To reset the system (ETR 18D/34D)
1.At a system administration extension (10 and 11); with the phone idle press Feature 0 0 followed by two presses
of Intercom 1. System Administration: is shown on the display.
2.Dial #728.
3.At the Reset - Save All prompt press Enter .
To reset the system (1408/1416 Phone)
1.At either of the system administration telephones (extensions 10 and 11), with the phone idle press Admin.
2.Use the up or down arrow buttons to scroll the display to System Administration. When displayed, press
Select.
3.Dial #728.
4.At the Reset - Save All prompt press Proceed.
14
To Next Page
Loading...
