Avaya PARTNER - Toll Call Prefix

PARTNER Phone Administration Page 44
- Issue 1b (22 February 2010)IP Office PARTNER Version
4.9 Toll Call Prefix
Use this feature to indicate whether users must dial a 0 (for operator assisted calls) or 1 (for direct-dial calls) before the
area code to make a long distance call or just the area code and number.
To change the toll call prefix setting (ETR 18D/34D)
1.At a system administration extension (10 and 11); with the phone idle press Feature 0 0 followed by two presses
of Intercom 1. System Administration: is shown on the display.
2.Dial #402. The phone displays Toll Call Prefix.
3.Enter the appropriate value:
· 1 = 0 or 1 required before Area Code and Number (the default setting).
· 2 = Area Code and Number Only.
· Exit programming by pressing Feature 00. You can also exit programming mode by lifting the handset, then place
it back in the cradle.
To change the toll call prefix setting (1408/1416 Phone)
1.At either of the system administration telephones (extensions 10 and 11), with the phone idle press Admin.
2.Use the up or down arrow buttons to scroll the display to System Administration. When displayed, press
Select.
3.Use the up or down arrow buttons to scroll the display to Restrictions/Permissions. When displayed,
press Select.
· Alternatively, dial # and the same code as used by ETR phones for system administration .
4.Use the up or down arrow buttons to scroll the display to Toll Call Prefix. When displayed, press Select.
5.At the Entry: prompt enter the list entry you want to change by entering 01 to 10.
6.The current setting is displayed.
7.Enter 1 or 2. Alternatively use the left or right arrow icons to toggle the settings or Default to return to the
default setting.
· 1 = 0 or 1 required before Area Code and Number (the default setting).
· 2 = Area Code and Number Only.
· Exit programming by pressing PHONE/EXIT. Alternatively use the Back button to move to another menu.
7