PARTNER Phone Administration Page 23
- Issue 1b (22 February 2010)IP Office PARTNER Version
Line Settings: Line Assignment
2.3 Line Coverage Extension
When an incoming call arrives on a line, it is presented to all extensions that have a line appearance button assigned
for that line. However for call coverage, VMS coverage and call forwarding it can be set to follow the settings of the
extension set below as the line's coverage extension.
To set a covering extension for a line (ETR 18D/34D)
1.At a system administration extension (10 and 11); with the phone idle press Feature 0 0 followed by two presses
of Intercom 1. System Administration: is shown on the display.
2.Dial #208. The phone displays Line Coverage Extension.
3.At the Line: prompt, enter the desired line number 01 to 64.
4.At the Extension: prompt enter the covering extension for the line.
· Exit programming by pressing Feature 00. You can also exit programming mode by lifting the handset, then place
it back in the cradle.
To set a covering extension for a line (1408/1416 Phone)
1.At either of the system administration telephones (extensions 10 and 11), with the phone idle press Admin.
2.Use the up or down arrow buttons to scroll the display to System Administration. When displayed, press
Select.
3.Use the up or down arrow buttons to scroll the display to Lines. When displayed, press Select.
· Alternatively, dial # and the same code as used by ETR phones for system administration .
4.Use the up or down arrow buttons to scroll the display to Line Coverage Extension. When displayed, press
Select.
5.At the Line: prompt, enter the desired line number 01 to 64.
6.At the Extension: prompt enter the covering extension for the line. Use the left or right arrow icons to toggle
through the extensions. Press Clear to remove to setting.
7.Use the up or down arrow buttons to select another line to adjust if required.
· Exit programming by pressing PHONE/EXIT. Alternatively use the Back button to move to another menu.
22
7
To Next Page
Loading...
