Avaya PARTNER - System Password

PARTNER Phone Administration Page 43
- Issue 1b (22 February 2010)IP Office PARTNER Version
Dialing Restrictions and Permissions: Allow Remote Call Forwarding
4.8 System Password
The system password is a four-digit password that users can enter from their telephones to override dialing restrictions if
the extension has access to an outside line. Through system administration you can set and change the system
password.
· The password overrides all dialing restrictions.
· Once a password is programmed, you must enter it to turn Night Service on and off. Additionally, if night
service is on, users in the Night Service Group must enter the password to make any outgoing calls except
calls to numbers on the Emergency Phone Number List and marked system speed dial numbers.
· Dialing restrictions for extensions not in the Night Service Group remain the same as during normal daytime
operation.
To change the system password (ETR 18D/34D)
1.At a system administration extension (10 and 11); with the phone idle press Feature 0 0 followed by two presses
of Intercom 1. System Administration: is shown on the display.
2.Dial #403. The phone displays Set System Password.
3.Enter a four-digit password.
· Exit programming by pressing Feature 00. You can also exit programming mode by lifting the handset, then place
it back in the cradle.
To change the system password (1408/1416 Phone)
1.At either of the system administration telephones (extensions 10 and 11), with the phone idle press Admin.
2.Use the up or down arrow buttons to scroll the display to System Administration. When displayed, press
Select.
3.Use the up or down arrow buttons to scroll the display to Restrictions/Permissions. When displayed,
press Select.
· Alternatively, dial # and the same code as used by ETR phones for system administration .
4.Use the up or down arrow buttons to scroll the display to Set System Password. When displayed, press
Select.
5.Enter the new four digit system password. Use Default to return to the default setting of no password.
· Exit programming by pressing PHONE/EXIT. Alternatively use the Back button to move to another menu.
94
93
40 59
7