Avaya PARTNER - Using Outcalling; About Outcalling

PARTNER Phone Administration Page 29
- Issue 1b (22 February 2010)IP Office PARTNER Version
Date and Time: Changing the System Date
3.2 Changing the System Time
The time shown on every display telephone can be changed. This should only be set on a system not using Network
Time Synchronization .
To change the system time (ETR 18D/34D)
1.At a system administration extension (10 and 11); with the phone idle press Feature 0 0 followed by two presses
of Intercom 1. System Administration: is shown on the display.
1.Dial #103. The phone will display System Time.
2.Enter the new time in the format HH:MM. The 24 hour clock is used, for example 4.22pm would be entered as
1622.
· Exit programming by pressing Feature 00. You can also exit programming mode by lifting the handset, then place
it back in the cradle.
To change the system time (1408/1416 Phone)
1.At either of the system administration telephones (extensions 10 and 11), with the phone idle press Admin.
2.Use the up or down arrow buttons to scroll the display to System Administration. When displayed, press
Select.
3.Use the up or down arrow buttons to scroll the display to System Parameters. When displayed, press
Select.
· Alternatively, dial # and the same code as used by ETR phones for system administration .
4.Use the up or down arrow buttons to scroll the display to System Time. When displayed, press Select.
5.The current date is displayed on HHMM format.
6.Enter the new system date in the format HHMM using the dial pad. The 24 hour clock is used, for example 4.22pm
would be entered as 1622.
· Exit programming by pressing PHONE/EXIT. Alternatively use the Back button to move to another menu.
30
7