Avaya PARTNER - Personal Ring Pattern; Personalized Station Ringing

PARTNER Phone Administration Page 103
- Issue 1b (22 February 2010)IP Office PARTNER Version
Ring Settings: Line Ringing
12.5 Personal Ring Pattern
Use this feature to assign a personalized ring pattern (choice of eight) to an ETR or tip/ring extension. Once a
personalized ring pattern is assigned to the extension, all incoming calls to that extension ring with the assigned ringing
pattern.
· The system does not pass distinctive ringing patterns generated by a PBX or central office through to extensions
(regardless of the setting for this feature).
To set an extension's personal ringing pattern (ETR 18D/34D)
1.At a system administration extension (10 and 11); with the phone idle press Feature 0 0 followed by two presses
of Intercom 1. System Administration: is shown on the display.
2.Dial #323. The phone displays Ring Pattern.
3.At the Extension: prompt, enter the number of the extension to be programmed.
4.At the Pattern prompt, enter a ringing pattern number 1 to 8. 1 is the default setting.
· Exit programming by pressing Feature 00. You can also exit programming mode by lifting the handset, then place
it back in the cradle.
To set an extension's personal ringing pattern (1408/1416 Phone)
1.At either of the system administration telephones (extensions 10 and 11), with the phone idle press Admin.
2.Use the up or down arrow buttons to scroll the display to System Administration. When displayed, press
Select.
3.Use the up or down arrow buttons to scroll the display to Extensions. When displayed, press Select.
· Alternatively, dial # and the same code as used by ETR phones for system administration .
4.Use the up or down arrow buttons to scroll the display to Ring Pattern. When displayed, press Select.
5.At the Extension: prompt enter the extension you want to edit.
6.The current setting is displayed.
7.Enter 1 to 8. Alternatively use the left or right arrow icons to toggle through the settings or Default to return
to the default setting (Pattern 1).
8.Use the up or down arrow buttons to select another extension to adjust if required.
· Exit programming by pressing PHONE/EXIT. Alternatively use the Back button to move to another menu.
7