PARTNER Phone Administration Page 123
- Issue 1b (22 February 2010)IP Office PARTNER Version
Button Programming: Call Coverage
14.8 Call Forwarding
A button set to this function allows the user to redirect all their calls to another number. Extensions with Remote Call
Forwarding enabled can also forward calls externally by specifying a personal speed dial as the destination.
· If an extension already has a button set to this function, creating another button with this function will
automatically clear the setting from the existing button.
· For analog lines and T1 lines without DID, the extension must be the Line Coverage Extension for that line.
· You can forward outside, intercom, transferred and voice signaled calls.
· You cannot forward group calls, calls to doorphone alert extensions, coverage calls, transfer-return calls and night
service calls.
· The system will only forward calls on lines that have reliable disconnect. For these lines, Hold Disconnect Time
must be set to a value other than 00 (No Detection).
· The extension must have an available line to forward the call to an outside number.
· The system uses the extension’s Automatic Line Selection to determine which line to use for the outgoing call.
· Extension's with Remote Call Forwarding enabled can also forward calls externally by specifying a personal
speed dial (80 to 99) as the destination.
· Specifying * followed by a personal speed dial is used for cell phone connect/mobile twinning. This operates in
the same way as remote call forwarding but rings at both the extension and the external number. Use of cell
phone connect may also require licenses.
· You can also access this option by pressing FEATURE 11 and entering the destination number. To switch
forwarding off enter the extension's own number as the destination.
· Programming the destination and/or the originator onto the call coverage button is optional.
To create a call forwarding button (ETR 18D/ETR 34D Phone)
1.Do one of the following depending on whether you want to change the button programming of the extension or of
another extension.
To program another extension
1.At the phone press Feature 00.
2.Program Extension: is shown on the
display.
3.Press the button that you want to edit or
enter from 03 to 80 or press the
corresponding line appearance button
directly.
1.At one of the system administration telephones (extension 10
and 11), press Feature 00 followed by two presses of
Intercom 1 and one press of Intercom 2. Centralized
Programming: is shown on the display.
2.At the Extension: prompt enter the number of the extension.
3.Enter from 03 to 80 to select the line button you want to edit or
press the corresponding line appearance button directly.
4.The current setting of that button is displayed.
3.Dial FEATURE 11.
4.At the Call Coverage Orig: prompt enter the extension number for which the button is being programmed.
5.At the Call Coverage Dest: prompt enter the destination number for the call forwarding calls.
· To forward to an external number, enter the personal speed dial (80 to 99) that contains the required external
number.
· To forward using cell phone connect/mobile twinning, enter * followed by the personal speed dial (80 to 99)
that contains the required external number.
6.The current setting of the button will now be set to Call Forward O <covered extension> D <destination
extension>.
· Exit programming by pressing Feature 00. You can also exit programming mode by lifting the handset, then place
it back in the cradle.
To create a call forwarding button (1408/1416 Phone)
1.Do one of the following depending on whether you want to change the button programming of the extension or of
another extension.
To program another extension
1.At the extension press Admin.
2.Press the programmable button you
want to change. Alternatively:
1.At extension 10 or 11, press Admin.
2.Use the up or down arrow buttons to scroll the display to
Centralized Programming. When displayed, press Select.
To Next Page
Loading...
