Avaya PARTNER - Outgoing Call Restriction

PARTNER Phone Administration Page 41
- Issue 1b (22 February 2010)IP Office PARTNER Version
Dialing Restrictions and Permissions: Emergency Phone Number List
4.6 Outgoing Call Restriction
Use this feature to specify the types of outgoing calls that can be made on all lines at an extension.
· If the system is connected to a PBX or Centrex system and a dial-out code (usually 9) is needed to place calls
outside the PBX or Centrex system, the control unit may not be able to prevent calls for extensions restricted to
Local Only. If dialing restrictions are needed on Centrex lines, use Centrex restrictions instead.
· Outgoing Call Restriction also applies to lines that a user has access to with Direct Line Pickup—Idle Line.
· To override this feature, users can dial marked system speed dial number and numbers from an Allowed Phone
Number List and the Emergency Phone Number List .
To set the types of outgoing calls that can be made by an extension (ETR 18D/34D)
1.At a system administration extension (10 and 11); with the phone idle press Feature 0 0 followed by two presses
of Intercom 1. System Administration: is shown on the display.
2.Dial #401. The phone displays Outgoing Call Restr.
3.At the Extension: prompt, enter the number of the extension to be programmed.
4.To change the type of call restriction, enter the appropriate value:
· 1 = No Restriction (can make toll, local and intercom calls; this is the default setting).
· 2 = Inside (intercom) only.
· 3 = Local (intercom and local) only.
· Exit programming by pressing Feature 00. You can also exit programming mode by lifting the handset, then place
it back in the cradle.
To set the types of outgoing calls that can be made by an extension (1408/1416 Phone)
1.At either of the system administration telephones (extensions 10 and 11), with the phone idle press Admin.
2.Use the up or down arrow buttons to scroll the display to System Administration. When displayed, press
Select.
3.Use the up or down arrow buttons to scroll the display to Restrictions/Permissions. When displayed,
press Select.
· Alternatively, dial # and the same code as used by ETR phones for system administration .
4.Use the up or down arrow buttons to scroll the display to Outgoing Call Restr. When displayed, press
Select.
5.At the Extension: prompt enter the extension you want to edit.
6.The current setting is displayed.
7.Enter 1, 2 or 3. Alternatively use the left or right arrow icons to toggle the settings or Default to return to
the default setting.
· 1 = No Restriction (can make toll, local and intercom calls; this is the default setting).
· 2 = Inside (intercom) only.
· 3 = Local (intercom and local) only.
· Exit programming by pressing PHONE/EXIT. Alternatively use the Back button to move to another menu.
59
35 40
7