Avaya PARTNER - Allow Remote Call Forwarding

PARTNER Phone Administration Page 42
- Issue 1b (22 February 2010)IP Office PARTNER Version
4.7 Allow Remote Call Forwarding
All extensions can forward their incoming calls to another extension using call forwarding . This option is used to
configure whether the extension can also forward calls to external numbers (remote call forwarding and cell phone
connect).
· For analog lines and T1 lines without DID, the extension must be the Line Coverage Extension for that line.
· You can forward outside, intercom, transferred and voice signaled calls.
· You cannot forward group calls, calls to doorphone alert extensions, coverage calls, transfer-return calls and night
service calls.
· The system will only forward calls on lines that have reliable disconnect. For these lines, Hold Disconnect Time
must be set to a value other than 00 (No Detection).
· The extension must have an available line to forward the call to an outside number.
· The system uses the extension’s Automatic Line Selection to determine which line to use for the outgoing call.
To change the remote call forwarding setting for an extension (ETR 18D/34D)
1.At a system administration extension (10 and 11); with the phone idle press Feature 0 0 followed by two presses
of Intercom 1. System Administration: is shown on the display.
2.Dial #322. The phone displays Remote Call Forwarding.
3.Enter the number of the extension to be programmed.
4.Enter the appropriate value:
· 1 = Assigned.
· 2 = Not Assigned (the default setting).
· Exit programming by pressing Feature 00. You can also exit programming mode by lifting the handset, then place
it back in the cradle.
To change the remote call forwarding setting for an extension (1408/1416 Phone)
1.At either of the system administration telephones (extensions 10 and 11), with the phone idle press Admin.
2.Use the up or down arrow buttons to scroll the display to System Administration. When displayed, press
Select.
3.Use the up or down arrow buttons to scroll the display to Extensions. When displayed, press Select.
· Alternatively, dial # and the same code as used by ETR phones for system administration .
4.Use the up or down arrow buttons to scroll the display to Remote Call Forward. When displayed, press
Select.
5.At the Extension: prompt enter the extension you want to edit.
6.The current setting is displayed.
7.Enter 1 or 2. Alternatively use the left or right arrow icons to toggle the settings or Default to return to the
default setting.
· 1 = Assigned.
· 2 = Not Assigned (the default setting).
8.Use the up or down arrow buttons to select another extension to adjust if required.
· Exit programming by pressing PHONE/EXIT. Alternatively use the Back button to move to another menu.
123
23
25
26
7