Avaya PARTNER - Changing the System Date

To Next Page

To Previous Page

PARTNER Phone Administration Page 28

- Issue 1b (22 February 2010)IP Office PARTNER Version

3. Date and Time

· Change the System Date

Set the date displayed on phones and used by the system.

· Change the System Time

Set the time displayed on phones and used by the system.

· Network Time Synchronization

Instead of manually setting the date and time, use the information provided by the service provider on calls with

incoming caller ID to automatically update the system date and time.

· Automatic Daylight Savings Time

Set the system to automatically adjust the system date and time to match daylight saving changes.

3.1 Changing the System Date

The date held by the system and shown on display telephones can be changed. This should only be set on a system not

using Network Time Synchronization .

To change the system date (ETR 18D/34D)

1.At a system administration extension (10 and 11); with the phone idle press Feature 0 0 followed by two presses

of Intercom 1. System Administration: is shown on the display.

2.Dial #101. The phone will display System Date.

3.Enter the new system date in the format MMDDYY using the dial pad. For example 120409 would be used to enter

the date December 4th 2009.

· Exit programming by pressing Feature 00. You can also exit programming mode by lifting the handset, then place

it back in the cradle.

To change the system date (1408/1416 Phone)

1.At either of the system administration telephones (extensions 10 and 11), with the phone idle press Admin.

2.Use the up or down arrow buttons to scroll the display to System Administration. When displayed, press

Select.

3.Use the up or down arrow buttons to scroll the display to System Parameters. When displayed, press

Select.

· Alternatively, dial # and the same code as used by ETR phones for system administration .

4.Use the up or down arrow buttons to scroll the display to System Date. When displayed, press Select.

5.The current date is displayed on MMDDYY format.

6.Enter the new system date in the format MMDDYY using the dial pad. For example 120409 is the date December

4th 2009.

· Exit programming by pressing PHONE/EXIT. Alternatively use the Back button to move to another menu.

Other manuals for Avaya PARTNER