Avaya PARTNER - Disallowed List Assignment; Disallowed List Assignments

PARTNER Phone Administration Page 39
- Issue 1b (22 February 2010)IP Office PARTNER Version
Dialing Restrictions and Permissions: Disallowed Number Lists
4.4 Disallowed List Assignment
Use this feature to assign which disallowed number lists an extension can use.
To assign Disallowed Phone Number Lists to an extension (ETR 18D/34D)
1.At a system administration extension (10 and 11); with the phone idle press Feature 0 0 followed by two presses
of Intercom 1. System Administration: is shown on the display.
2.Dial #405. The phone displays Disallow To.
3.Enter the number of the extension to be programmed.
4.Enter the list number 1 to 8.
5.Enter the appropriate value:
· 1 = Assigned to extension
· 2 = Not Assigned to extension (the default setting)
· Exit programming by pressing Feature 00. You can also exit programming mode by lifting the handset, then place
it back in the cradle.
To assign allowed phone number lists to an extension (1408/1416 Phone)
1.At either of the system administration telephones (extensions 10 and 11), with the phone idle press Admin.
2.Use the up or down arrow buttons to scroll the display to System Administration. When displayed, press
Select.
3.Use the up or down arrow buttons to scroll the display to Restrictions/Permissions. When displayed,
press Select.
· Alternatively, dial # and the same code as used by ETR phones for system administration .
4.Use the up or down arrow buttons to scroll the display to Disallow To. When displayed, press Select.
5.At the Extension: prompt enter the extension number for which you want to assign lists.
6.At the List Number: prompt enter the list entry you want to change by entering 1 to 8.
7.The current setting is displayed.
8.Enter 1 (Assigned) or 2 (Not assigned). Alternatively use the left or right arrow icons to toggle the settings or
Default to return to the default setting (Not assigned).
9.Use the up or down arrow buttons to scroll through the extension's setting for other lists if required.
· Exit programming by pressing PHONE/EXIT. Alternatively use the Back button to move to another menu.
37
7