Avaya PARTNER - Hold Recall Time

PARTNER Phone Administration Page 108
- Issue 1b (22 February 2010)IP Office PARTNER Version
13. Holding Calls
13.1 Hold Recall Time
Set how long a call can be placed on hold before recalling to the extension that put it on hold if that extension is idle.
To change the hold recall time (ETR 18D/34D)
1.At a system administration extension (10 and 11); with the phone idle press Feature 0 0 followed by two presses
of Intercom 1. System Administration: is shown on the display.
2.Dial #127. The phone displays Hold Timer.
3.Press the appropriate digit to change the value:
0 = Not Active
3 = 30 seconds
6 = 90 seconds
9 = 180 seconds
1 = 10 seconds
4 = 45 seconds
7 = 120 seconds
2 = 20 seconds
5 = 60 seconds
(the default setting)
8 = 150 seconds
· Exit programming by pressing Feature 00. You can also exit programming mode by lifting the handset, then place
it back in the cradle.
To change the hold recall time (1408/1416 Phone)
1.At either of the system administration telephones (extensions 10 and 11), with the phone idle press Admin.
2.Use the up or down arrow buttons to scroll the display to System Administration. When displayed, press
Select.
3.Use the up or down arrow buttons to scroll the display to System Parameters. When displayed, press
Select.
· Alternatively, dial # and the same code as used by ETR phones for system administration .
4.Use the up or down arrow buttons to scroll the display to Hold Timer. When displayed, press Select.
5.The current setting is displayed.
6.Enter then option required 0 (off) to 9. Alternatively use the left or right arrow icons to toggle the settings or
Default to return to the default setting (5).
0 = Not Active
3 = 30 seconds
6 = 90 seconds
9 = 180 seconds
1 = 10 seconds
4 = 45 seconds
7 = 120 seconds
2 = 20 seconds
5 = 60 seconds
(the default setting)
8 = 150 seconds
· Exit programming by pressing PHONE/EXIT. Alternatively use the Back button to move to another menu.
7