PARTNER Phone Administration Page 138
- Issue 1b (22 February 2010)IP Office PARTNER Version
14.22 Loudspeaker Page
A button set to this function allows the user to make a page call to the extension configured as being connected to the
loudspeaker equipment .
· If an extension already has a button set to this function, creating another button with this function will
automatically clear the setting from the existing button.
· To access this function without a programmable button, press Intercom 1 or Intercom 2 and then dial 70.
To create a loudspeaker page button (ETR 18D/ETR 34D Phone)
1.Do one of the following depending on whether you want to change the button programming of the extension or of
another extension.
To program another extension
1.At the phone press Feature 00.
2.Program Extension: is shown on the
display.
3.Press the button that you want to edit or
enter from 03 to 80 or press the
corresponding line appearance button
directly.
1.At one of the system administration telephones (extension 10
and 11), press Feature 00 followed by two presses of
Intercom 1 and one press of Intercom 2. Centralized
Programming: is shown on the display.
2.At the Extension: prompt enter the number of the extension.
3.Enter from 03 to 80 to select the line button you want to edit or
press the corresponding line appearance button directly.
4.The current setting of that button is displayed.
3.Press Intercom 1 and dial 70.
4.The current setting of the button will now be set to Loudspeaker Page.
· Exit programming by pressing Feature 00. You can also exit programming mode by lifting the handset, then place
it back in the cradle.
To create a loudspeaker page button (1408/1416 Phone)
1.Do one of the following depending on whether you want to change the button programming of the extension or of
another extension.
To program another extension
1.At the extension press Admin.
2.Press the programmable button you
want to change. Alternatively:
· Use the up or down arrows to
scroll to Telephone Programming
. Press Select.
· At the Button: prompt press the
button to edit or enter from 03 to
80 or press the corresponding line
appearance button directly.
1.At extension 10 or 11, press Admin.
2.Use the up or down arrow buttons to scroll the display to
Centralized Programming. When displayed, press Select.
3.At the Extension: prompt enter the extension that you want to
configure.
4.Use the up or down arrow buttons to scroll the display to
Button Programming. When displayed, press Select.
5.At the Button: prompt enter from 03 to 80 or press the
corresponding line appearance button directly..
2.The current setting of that button is displayed.
4.Press Program and either press Intercom 1 or use the up or down arrow buttons to scroll the display to
Loudspeaker Page and press Select.
5.At the Endpoint: prompt enter 70.
6.The current setting of the button will now be set to Loudspeaker Page.
· Exit programming by pressing PHONE/EXIT. Alternatively use the Back button to move to another menu.
55
To Next Page
Loading...
