PARTNER Phone Administration Page 21
- Issue 1b (22 February 2010)IP Office PARTNER Version
Line Settings:
2.1 Number of Lines
This feature should only be used during initial system configuration before any other button programming
has been performed. If used at any other time, it will override that other button programming.
Use this feature to determine the number of outside lines that should be automatically assigned to buttons on all system
extensions. For example, entering 06 means that all extensions are assigned lines 01 through 06. The lines are assigned
to the buttons on every extension starting with button 03 upwards (buttons 01 and 02 are reserved for internal Intercom
1 and Intercom 2 buttons).
· You can use this feature to tell the system how many lines are actually connected at the control unit. If you do not
use this feature, the line numbers associated with empty jacks are assigned to telephones as though there were
actually lines connected.
· You can use this procedure to limit the number of lines that are automatically assigned to all extensions. For
example, if there are ten lines connected to the system, you can use this procedure to set the number of lines to
eight, so that only the first eight lines are assigned to all system extensions. You can then use Line Assignment to
assign lines 9 and 10 to specific extensions.
· To change line assignments without affecting other extensions and settings, use Line Assignment .
· Automatic Line Selection for all extensions is updated to match the same set of lines in sequence followed by
the intercom lines.
· If an extensions is assigned as a doorphone extension , its automatic line selection is reset to select
intercom buttons first.
To assign lines to the system (ETR 18D/34D)
1.At a system administration extension (10 and 11); with the phone idle press Feature 0 0 followed by two presses
of Intercom 1. System Administration: is shown on the display.
2.Dial #104.
3.Enter two digits for the number of outside lines in the system to assign to all extensions.
· Exit programming by pressing Feature 00. You can also exit programming mode by lifting the handset, then place
it back in the cradle.
To assign lines to the system (1408/1416 Phone)
1.At either of the system administration telephones (extensions 10 and 11), with the phone idle press Admin.
2.Use the up or down arrow buttons to scroll the display to System Administration. When displayed, press
Select.
3.Use the up or down arrow buttons to scroll the display to System Parameters. When displayed, press
Select.
· Alternatively, dial # and the same code as used by ETR phones for system administration .
4.Use the up or down arrow buttons to scroll the display to Number of Lines. When displayed, press Select.
5.The current setting is displayed.
6.Enter two digits for the number of lines. Alternatively use the left or right arrow icons to toggle through values
or Default to return to the default setting (4 lines).
· Exit programming by pressing PHONE/EXIT. Alternatively use the Back button to move to another menu.
22
26
51
7
To Next Page
Loading...
