PARTNER Phone Administration Page 73
- Issue 1b (22 February 2010)IP Office PARTNER Version
Extension Settings: External Hotline
To identify an external hotline extension (ETR 18D/34D)
1.At a system administration extension (10 and 11); with the phone idle press Feature 0 0 followed by two presses
of Intercom 1. System Administration: is shown on the display.
2.Dial #311. The phone displays External Hotline.
3.At the Extension: prompt, enter the external hotline extension number.
4.At the Extension: prompt enter the extension.
5.The current setting is displayed.
6.Enter the external number and press Enter. Press Clear to remove any existing number. The following keys can
be used to enter special dialing commands:
Inserts a 1.5 second pause.
Send a hook-switch flash signal.
· Exit programming by pressing Feature 00. You can also exit programming mode by lifting the handset, then place
it back in the cradle.
To identify an external hotline extension (1408/1416 Phone)
1.At either of the system administration telephones (extensions 10 and 11), with the phone idle press Admin.
2.Use the up or down arrow buttons to scroll the display to System Administration. When displayed, press
Select.
3.Use the up or down arrow buttons to scroll the display to Extensions. When displayed, press Select.
· Alternatively, dial # and the same code as used by ETR phones for system administration .
4.Use the up or down arrow buttons to scroll the display to External Hotline. When displayed, press Select.
5.At the Extension: prompt enter the extension.
6.The current setting is displayed.
7.Enter the external number and press Enter. Press Clear to remove any existing number. The following keys can
be used to enter special dialing commands:
Inserts a 1.5 second pause.
Send a hook-switch flash signal.
8.Use the up or down arrow buttons to select another extension to adjust if required.
· Exit programming by pressing PHONE/EXIT. Alternatively use the Back button to move to another menu.
7
To Next Page
Loading...
