Barco SIM 7Q HB - About the Manual; RACU Hand Held Control Unit

1. Introduction
1.2 About the manual
CAUTION: For the latest version of the product manuals, see http://www.barco.com.
Clarification of the term “SIM 7Q series” used in this document
When referring in this document to the term “SIM 7Q series” it is meant that the content is applicable for the following Barco products:
•SIM7Q
•SIM7QHB
•SIM7QHC
•SIM7QHB&C
Manual overview
This manual contains 6 main chapters :
1. Installation : the mechanical setup of the projector.
2. Setup : adjusting the projection parameters in order to get the best image reproduction.
3. Getting started : start the projector for daily use.
4. Advanced : advanced operation and setup settings using the remote control and the projector’s OSD.
5. Maintenance : projector’s maintenance operations
6. Service : basic service of the projector
Related documentation
Several advanced adjustments can be set and controlled via the Barco hand held remote control unit xRACU and are covered in the
dedicated System manual.
Image 1-2
RACU hand held control unit
Symbol overview
The following icons are used in the manual :
Caution
Warning
Info, term definition. General info about the term.
Note, gives extra information about the described subject.
Tip, gives extra advice about the described subject.
R59770066 SIM 7Q SERIES 07/10/2013 7