7. Advanced
7.8.7.2 Enabling Smearing reduction
When activating this function a drop in light output and a noticeable flicker is inevitable.
How to enable the Smearing reduction (if the option is installed) ?
1. Press MENU to activate the Tool bar
2. Press → to select the Dis play setup item
3. Press ↓ to Pull down the Display setup menu
4. Use ↑ or ↓ to select Smearing reduction
5. Press → to pull down the menu
6. Use ↓ or ↑ to enable (ON) or disable (OFF) the Smearing reduction
Image 7-147
7. Press ENTER
When disabling (OFF) the Smearing reduction the flicker will be noticeable (frequency will decrease notice-
ably). See warning above.
When disabling the Smearing reduction, the projector will try to get the full image displayed. This can take up
to one minute!
R59770066 SIM 7Q SERIES 07/10/2013 181
To Next Page
Loading...
