7. Advanced
7.8.9 Color temperature
What can be done ?
Changing the Color tem perature changes the coordinates of the white point of the projector. The color temperature can be selected
according to the type of source: next to Projector white, which is brightest white point that can be produced by the projector, 5
different presets are available:
•Projectorwhite
• Computer : 9300 K
• Video : 6500 K
• Film : 5400 K
• Broadcast : 3200 K
• Dynacolor white
These calibrated presets can be selected and will provide optimum color tracking. The projector however allows the setting of a
personal color temperature: this is done by changing the white point coordinates in Dynacolor.
Changing the color temperature while Dynacolor is enabled, will change the coordinates of the desired value
of the white point in the Dynacolor user interface.
If Dynacolor is enabled and the white point coordinates have been changed there, then the color temperature
will be set to Dynacolor white and the value will match the coordinates of the white point in the desired values
of the Dynacolor user interface.
How to select a preset color temperature ?
1. Press MENU to activate the tool bar
2. Press → to select the Dis play setup item
3. Press ↓ to pull down the Display setup menu
4. Use ↑ or ↓ to select Color temperature
5. Press → to pull down the menu
6. Use ↓ or ↑ to select the desired preset color temperature
Image 7-151
7. Press ENTER
The color temperature of the image is adapted and a bullet shows the active setting.
How to set a custom color temperature ?
1. Change the coordinates of the white point in the Dynacolor user interface
184
R59770066 SIM 7Q SERIES 07/10/2013
To Next Page
Loading...
