Barco SIM 7Q HB - Installing the Electronics Filter; Electronics Filter: Install; Electronics Filter Cover: Mounting; Exact Position of the Cover against the Electronics Filter

8. Maintenance
8.3.4 Installing the electronics filter
Necessary tools
Torx screwdriver T10
How to install the electronics filter?
1. Insert the electronics filter in its housing until it sticks out only a few centimeters
Image 8-14
Electronics filter: install
Note: The seal of the air filter must point down!
Note: The obliged air flow direction is indicated by an arrow on the label at the edge of the air filter.
2. Place the electronics filter cover against the electronics filter
Image 8-15
Electronics filter cover: mounting
Image 8-16
Exact position of the cover against the electronics filter
3. Push the electronics filter completely in its housing
Image 8-17
Electronics filter: push it in.
242 R59770066 SIM 7Q SERIES 07/10/2013