7. Advanced
7.8.5.3.3 Creating/editing a soft edge
Description
In this example we will create an internal soft edge where we will adjust the left side zone (displace one point along the x axis).
How to start up the edit dialog box ?
1. Press the MENU key to activate the Tool bar.
2. Push the cursor key ← or → to highlight Display setup
3. Push the ↓ key to pull down the menu.
4. Push ↓or ↑ to select S oft edge
5. Push the → key to pull down the menu.
6. Push the cursor key ← or → to highlight Edit...
Image 7-125
7. Press ENTER
The soft edge dialog box will be displayed.
How to select the soft edge type ?
The internal soft edge type is selected by default
1. Push ↓or ↑ to select the Internal check box
The item is focused
Image 7-126
R59770066 SIM 7Q SERIES 07/10/2013 165
To Next Page
Loading...
